User's Manual
Table Of Contents
- Product Registration
- Important Information
- Contents
- About SMART Response
- Installing SMART Response
- Managing SMART Response
- Managing Class Lists
- Connecting and Disconnecting the Clickers
- Using SMART Response
- Using SMART Notebook to Ask Questions and Create Assessments
- Question Types
- Asking Questions with SMART Notebook
- Adding Questions with the Insert Question Wizard
- Creating Assessments
- Tagging questions
- Adding a Content Page
- Importing Questions from a Microsoft Word Document
- Importing Questions from XML or SQZ Files
- Importing Questions from a PDF File
- Printing from SMART Notebook Software’s Response Menu
- Exporting Results to an Excel, HTML or CSV File
- Using SMART Response Software in the Classroom
- Maintaining SMART Response
- Hardware Environmental Compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE Directive)
- Restriction of Certain Chemicals (REACH Directive)
- Restriction of Certain Hazardous Substances (RoHS Directive)
- Batteries
- Packaging
- Covered Electronics Devices
- China’s Electronic Information Products Regulations
- U.S. Consumer Product Safety Improvement Act
- Customer Support
70 | CHAPTER 9 – MAINTAINING SMART RESPONSE
To change the
clicker batteries
1. Using the included Phillips® screwdriver, remove the screw from the back of the
clicker, and then remove the cover.
2. Remove the exhausted batteries, and dispose of them according to local
regulations.
3. Insert new AA batteries.
The clicker turns on.
4. Replace the cover and screw.
5. Verify that the start-up menu appears.
6. Press Power for one to two seconds to turn the clicker off.
The Receiver Indicators
Receivers have the following indicators:
• The Ready light
• The Transmit light
• The Receive light
The Ready light LED is in the upper-right corner of the receiver’s enclosure. The
Ready light indicates the operational states of the receiver module. You can see the
Transmit and Receive lights in the lower-right part of the receiver’s enclosure. The
lights flash green, indicating transmit and receive activity between the receiver and
the clickers.
NOTE
The following table shows the Ready light’s normal states. If the light’s behavior
doesn’t match a state listed here, refer to the Troubleshooting the Receiver
section.
Ready Light State Meaning
Off The receiver is disconnected from the computer, or
SMART Response Manager has placed the
receiver into Off (PowerSave) mode.
Solid red The receiver has power, but it’s not communicating
with the computer.
Solid green The receiver is receiving power and communicating
successfully with SMART Response.