User's Manual
Table Of Contents
- Important information
- About SMART Response
- Installing SMART Response
- Getting started
- Using SMART Response
- About SMART Notebook
- Creating Assessments
- Adding questions to the assessment
- About question types
- About intelligent expression grading
- Adding questions using the Insert Question wizard
- Importing questions from a Word document
- Example Word document question formats
- Importing questions from an XML or SQZ file
- Importing questions from a PDF file
- Adding choices to a question
- Tagging questions
- Starting and connecting to a class
- Disconnecting students from a class
- Using clickers
- Completing assessments
- Reviewing, printing and exporting assessment results
- Maintaining SMART Response
- Hardware environmental compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE directive)
- Restriction of Certain Hazardous Substances (RoHS directive)
- Batteries
- Packaging
- Covered Electronics Devices
- China’s Electronic Information Products regulations
- U.S. Consumer Product Safety Improvement Act
- California Air Resource Board – Airborne Toxic Control Measure
- Restriction of Certain Chemicals (REACH directive)
- Customer support
8 1
4. Insert new AA batteries.
5. Replace the cover and screw.
Resetting clickers
If your clicker isn't operating as expected, you may need to reset it. Perform the following
steps to reset it.
To reset the clicker 1. If the clicker is on, turn it off.
2. Using the included Phillips® screwdriver, remove the screw from the back of the
clicker, and then remove the cover.
3. Remove the batteries.
4. Press and hold the Power button for at least 5 seconds.
5. Replace the batteries.
6. Replace the cover and screw.
Receiver indicator lights
Receivers have the following LEDindicator lights:
l The Ready light
l The Transmit light
l The Receive light
The Ready light is in the upper-right corner of the receiver. The Ready light indicates the
operational states of the receiver module. You can see the Transmit and Receive lights
in the lower-right part of the receiver. The lights flash green, indicating transmit and
receive activity between the receiver and the clickers.
The following table shows the Ready light’s normal states. If the light’s behavior doesn’t
match a state listed here, refer to Troubleshooting the receiver on next page.
Ready Light
State
Description
Off The receiver is disconnected from the computer.
| C H A P T E R 6 – M A I N T A I N I N G S M A R T R E S P O N S E