Smart Tiles will stick permanently to your walls, that's our guarantee! The guarantee also applies to design
or manufacturing defects.
For the warranty to be valid, certain conditions
apply:
Wait a period of three (3) weeks before affixing S mart Tiles on a freshly painted wall to allow the paint to
penetrate and dry thoroughly.
The surface must be smooth and undamaged.
The surface must be clean and dry.
You should clean the surface with a degreaser such as T.S.P. (trisodium phosphate).
During installation, the ambient temperature must be at least 65 °F (18 °C) and should not exceed 95 °F (35
°C).
Smart Tiles should not be exposed to direct steam, or be in direct contact with a heat source and should not
be submerged in water (do not install in the shower).
To install behind a gas range without a protective rear panel, allow a height of 15 inches (38 centimeters)
above the surface to prevent the tiles from co ming in contact with open flame. If there is a wall to the right or
left side of the range, Smart Tiles must be installed at least two inches (six centimeters) away.
Keep a distance of two inches (six centimeters) bet ween an oven toaster grill and wall covered with Smart
Tiles.
If you decide to remove the Smart Tiles once they have been firmly applied, they cannot be reused.
Smart Tiles are not designed to cover a floor, countertop or work surface, or to serve as a trivet.
For maintenance, you should only use a mild non-abrasive product.
More details on www.thesmarttiles.com
 
 

Summary of content (1 pages)

Open in iOS application

Don't see a manual you are looking for?