User Guide

Chapter 2 Using the stand
smarttech.com/kb/171370 12
8. After the stand is moved, flip the caster brakes down to lock them and secure the stand in place.
9. Connect the power cable to the outlet and secure any cables that run along the floor.
Raising and lowering the stand
Warnings
l
Ensure the locking bolts are securely tightened before operating the stand.
l
Do not allow children or people who are not able to safely operate the stand to use it.
l
Lock the casters before raising or lowering the stand.
l
Operating the stand can create a hand-crushing or hand-pinching hazard. To prevent injury,
keep hands and people away from crush and pinch locations on the stand.
l
Allow adequate clearance above and below the stand to ensure safe raising and lowering.
l
Use the stand only on a flat surface.
Caution
Do not raise and lower the stand for more than two minutes at a time.
Calibrating the stand
The stand needs to be calibrated before you start to use it.
To calibrate the stand
1. Connect the stand to a power outlet.
2.
Press the Down button and lower the stand to the lowest position.
3.
Press the Down button for 5 seconds and then release it.
The stand moves up and down 1 cm.
Resetting the stand
If the stand lowers but does not move when you try raising it or if you replace the controller, perform a
factory reset by following the steps below.