User`s guide
Table Of Contents
- Cover page
- Important information for your interactive flat panel
- Chapter 1: About your interactive flat panel
- Chapter 2: Installing your interactive flat panel
- Chapter 3: Connecting computers and peripheral devices
- Chapter 4: Installing SMART software
- Chapter 5: Using your interactive flat panel
- Turning on and turning off your interactive flat panel
- Understanding presence detection
- Using the infrared remote control
- Getting started with your SMART Board interactive flat panel
- Playing audio files on your interactive flat panel
- Using the USB receptacle
- Chapter 6: Using guest laptops with your interactive flat panel
- Chapter 7: Maintaining your interactive flat panel
- Updating your SMART software and firmware
- Calibrating your interactive flat panel
- Orienting your interactive flat panel
- Replacing a pen nib
- Cleaning the screen
- Cleaning the presence detection sensors
- Cleaning the camera windows and reflective tape
- Maintaining ventilation
- Preventing condensation
- Checking the interactive flat panel installation
- Removing your interactive flat panel
- Transporting your interactive flat panel
- Chapter 8: Troubleshooting for your interactive flat panel
- Appendix A: Adjusting video settings with the on-screen display menu
- Appendix B: Hardware environmental compliance
- Index
g To remove the interactive flat panel
1. Turn off your interactive flat panel and unplug the power cable from the wall outlet.
2. Remove all accessible cables and connectors.
W A R N I N G
o
Do not move the interactive flat panel by connecting a rope or wire to the handles on
the back. The interactive flat panel can fall and cause personal injury and product
damage.
3. There are two lifting handles on the back of the interactive flat panel, one on each side. With
one person on each end, use one hand each on the handle to support the weight of the
interactive flat panel and the other hand on the upper side to balance it during lifting. The
interactive flat panel weighs about 98 lb. (44.5 kg).
4. Lift your interactive flat panel from its mounting location.
C A U T I ON
o
Do not allow the weight of the interactive flat panel to rest on the color select module
because it is not designed to support product weight.
o
Do not leave the interactive flat panel face up, face down or upside down for an
extended period of time as it could cause permanent damage to the screen.
C H A P T E R 7
Maintaining your interactive flat panel
59