User Manual

－ 25 －
Traceability control system PC software
alert are activated continuously.
Retention：It will work until it is canceled by manual operation.
7) Over torque counting function (Only for HTW)
Do not count: When torque data has exceeded <Upper torque>, <Control number function>
does not count.
Count: When torque data has exceeded <Upper torque>, <Control number function> counts.
* Please refer to the next page for details.
8) Power OFF Memory (Only for HTW)
Delete: When power is turned off in the middle of <Control number function>, the number of
tightening times already counted is cleared.
Save: When power is turned off in the middle of <Control number function>, the number of
tightening times already counted is saved.
9) Count display method
Subtraction: When the counter for <Control number function> is set, the number of times
counts down (displays the remaining number of tightening times).
Addition: When the counter for <Control number function> is set, the number of times counts
up (displays the number of tightening times given).
10) Tightening direction
Clockwise: Tightening will be completed when the torque has reached the set level only in the
direction (+/-) set on <Setting operation>.
Both directions: Tightening will be completed when the torque has reached the set level in
either direction regardless of the direction (+/-) set on <Setting operation>.
the tightening direction is represented by plus and minus signs.
* Please refer to the next page for details.
11) Alarm sound operation
0.3 sec to 1.2 sec (increment of 0.1 sec) Sets the duration of LCD display, buzzer and vibrating
alert to be activated when the torque has reached <Lower torque>.
12) buzzer sound
Lower torque：Sets the buzzer tone between 0 and 10 to use when the torque has reached
<Lower torque>.
Upper torque：Sets the buzzer tone between 0 and 10 to use when the torque has reached
<Upper torque>.
8-4) Saving and loading of maintenance data
1) Saving of maintenance data
＜Menu bar＞ → File → Save ＜Save＞icon
2) Loading of maintenance data
＜Menu bar＞ → File → Open ＜Open＞icon