User Manual

－16－
Traceability control system PC software
2) Poka-yoke function
Until it reaches a value that the torque value has been set, when the torque wrench in the
“Specified angle " or more does not rotate , it is determined that had been tightening already in
the " lower torque " , and warning .
Work data is not recorded, will not be sent.
3) Screw tightening inspection function
It performs a tightening to the specified torque to the screw tightening is complete , if the
torque wrench to the "Tolerance angle" or more is rotated , the screw that was carried out
inspection leaves a record that was " loose ".
Inspection results
5 places check the results of the, leaving the record of screws "screw loose" in the < third >.
It should be noted and the appropriate screws will be that it has been tightening in the " 8.18N ·
m ".
☞

Point
"Specified angle" to be set depends on the conditions of the type and the bearing
surface of the screw.
In advance , please decide the set value on that was verified .
Point
f you tighten directly to the base material, please try to set in about "5 degrees".
Please try to set in the "10 degrees" If you are using a flat washer and spring
washer.