Owners manual

14
USING RS-232 CONTROL (continued)
To switch ports, type “sw [output] 1-32[input] 1-32 <enter>”:
Example:
DBG>sw 2 2
This switches Output 2 to Input 2
To set the broadcast por t , type “ br [input] 1-32<en t er>”:
Example:
DBG>br 2
This will send input 2 to all outputs.
DBG>br \
Sets 1:1 mode.
IN 1 to OUT 1
IN 2 to OUT 2
IN 3 to OUT 3
Etc.
DBG>br /
Sets inverse 1:1 mode.
IN 1 to OUT 32
IN 2 to OUT 31
IN 3 to OUT 30
Etc.
To learn an EDID type “edid [map (1-2) | s]”
The system will respond with the name of the EDID that has been learned.
Each card will display whether or not the EDID was learned successfully.
Examples:
DBG>edid 1
This will load the factory setting 1 EDID (SM HD) for HDMI 1080p with no audio.
DBG>edid 2
This will load the factory setting 2 EDID (SM HDAU) for HDMI 1080p including audio.
DBG>edid s
This will load the EDID of the display connected to output port 1