Installation Guide

08212020
EXCLUSIVELY AT LOWE’S®
LEARN MORE AT LOWES.COM
Planks: Use the cut-o end from the previous
row to begin the next row. If the cut-o end is
less than 8", cut a new plank to be 8" or more to
start the next row.
Tiles: Always begin a row with either a full tile or
a half tile so the joints are consistently staggered
in a “brick work” type pattern.
Remember to stagger end joints from row to row – 8+" for planks and 12+" for tiles.
Repeat steps to finish the room Enjoy your new floor!
Tap the length end to ensure a tight fit,
then tap the short end to drive down the
short end tongue into groove.
Connect the length side at a slight angle
and rotate down.
Lock the short ends together to complete
your first row. Cut the planks as needed to
fit the space.
Start your second row. With a cut-off
that is more than 8" long or start with
a new plank.
Use a scrap piece of plank to keep the joints lined up.
This is called a “bridge.”