Operator’s Manual Manual del Usuario Battery Charger Cargador de batería Model/Modelo BC-15000 AC Input: 100-120VAC, 50-60Hz, 350W Max DC Output: 6VDC, 5A; 12VDC, 15A; 12VDC, 20A (5 minutes) Temperature Controlled Smartech Inc. • 8700 Larkin Rd.
IMPORTANT SAFETY INSTRUCTIONS 11. NEVER charge a frozen, damaged, leaking or non-rechargeable battery. WARNING! Read and understand all Important Safety and Operating instructions before using this charger. In addition, read and follow all battery and vehicle manufacturer’s instructions and cautionary markings. SAFETY PRECAUTIONS FOR WORKING IN THE VICINITY OF A BATTERY 1. Batteries generate explosive gases during normal operation. Use in wellventilated area. 2.
CHARGER FEATURES • This charger is designed for all types of 12V Lead-acid and 12V Lithiumion batteries, including WET (Flooded), GEL, MF (Maintenance-Free), EFB (Enhanced Flooded Battery), AGM (Absorbed Glass Mat) and LiION (Lithium Ion) batteries. • Built-in intelligent microprocessor makes charging faster, easier and safer. • This charger has safety features, including spark proof, protection for reverse polarity, short circuit, overcurrent, overcharge and overheat.
the 12V adapter plug into the vehicle’s 12V outlet. If the vehicle’s ignition key has to be on in order for the 12V outlet to supply/receive power, turn the key without starting the engine. 9. A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment specially designed for marine use. CHARGER MODES The charger has nine modes: Standby, 12V NORM, 12V COLD/AGM, 6V NORM, 12V AGM+, 12V LITHIUM, REPAIR, 13.6V SUPPLY and 12V BOOST CHARGE.
minimize risks, disconnect the battery from the vehicle before using this mode. 13.6V SUPPLY – Once at + REPAIR tap CHARGE MODE to access This mode converts the charger to a constant voltage, constant current DC power supply. When the charger is not connected with battery, it can be used to power 12VDC devices. Prior to use, read your 12VDC device manual to determine if it is suitable for use with this mode.
LED COMMUNICATION OF ABNORMAL RESULTS LIGHT CONDITION CAUSE SOLUTION LIGHT CONDITION CAUSE SOLUTION Solid Red Warning Reverse Polarity Change red and black clamps to the correct battery posts 1. Open-circuit 2. Dirty Battery Posts 3. Dead Battery (voltage below 1V) 4. Output Short Circuit 1. Connect the red and black clamps to battery posts 2. Clean the battery posts 3. Replace the battery with a new one immediately 4.
NOTICE: The following situation indicates the need for battery replacement, although there is no abnormal LED communication: After a full charging cycle and with 100% battery level indication, if engine cannot be started (excluding problem with vehicle itself), the battery may no longer have electrical storage capacity. Take battery for evaluation to a battery service dealer.