User Manual

SmarTek Systems (www.smarteksys.com)

<OC1>,<OC2>,<OC3>,<OC4>,<OC5>,<SN1>,<SN2>,<SN3>,<SN4>,<SN5>,

<T_Floor>,<Add_Noiset>}

All parameters are bytes and are offset by +32 (20 Hex).

For SAS-1 software versions SAS_131 and above, the Send Parameters command not only

sends parameters to the SAS-1, but causes the parameters to be written to non-volatile

flash memory.

SAS-1 Response:

No Response.

Command to SAS-1: Set SAS Baud Rate

<ESC>{SASxxxx,BAUD=Baud_Rate}

Baud_Rate is a byte and is offset by +32 (20 Hex).

Baud_Rate = 0 “2400 bps” This rate will not support TAI or RELAY operating modes.

1 “4800 bps” This rate will not support TAI or RELAY operating modes.

2 “9600 bps” This rate will not support support RELAY mode.

3 “19200 bps” This rate will not support RELAY mode.

4 “38400 bps”

5 “57600 bps”

6 “115200 bps”

SAS-1 Response:

Chr(2)OKChr(3) “OK” is ASCII.

Command to SAS-1: Save Parameters to SAS-1 NonVolatile Memory

<ESC>{SASxxxx,WPRM}

SAS-1 Response:

Chr(2)OKChr(3) “OK” is ASCII.

For SAS-1 Software Revision SAS_131 or higher, this command has no effect.

Command to SAS-1: Get SAS-1 ID

<ESC>{SAS0000,GETID}