Use and Care Manual

14
©2012 Smarter Tools, Inc. All Rights Reserved
7500 Generator
Controls and Features (cont’d)
_________________________________________________________________________________________________
Control Panel
1. Engine Switch – Used to turn on and off the
engine. For electric models it is also used to
start the engine.
2. Hour Meter – Measures the number or hours
the engine has run and displays the voltage/Hz
produced by generator.
3. Circuit Breakers – Protects the generator
against electrical overload.
4. (2) 120V 20A Duplexes – These duplexes are
protected by a (2) 20A circuit breakers. Use
each duplex to operate 120 volt AC, single
phase, 60 Hz loads requiring up to 20 A or 2400
Watts of power.
5. 120/240V 30A Twist-Lock – Protected by a 30A
circuit breaker on each 120 Volt leg of the
receptacle. This receptacle powers 240 Volt AC,
60 Hz, single phase loads requiring up to 30A or
7200 Watts of power. If an L14-30P plug is wired
for only one 120 Volt leg (3-wire connection)
then this receptacle powers 120 Volt AC, 60 Hz,
single phase loads requiring up to 30A or 3600
Watts of power.
6. 120V 30A Twist-Lock– This outlet is protected
by a 30A circuit breaker. Use this Twist-Lock to
operate 120 volt AC, single phase, 60 Hz loads
requiring up to 30A or 3600 Watts of power.
7. 12V DC Connectors – Use to charge 12V DC
batteries
8. General Specifications
9. Ground Terminal – Consult an electrician for
local grounding regulations.