User's Guide

Test Conditions

The Smartfall has been tested under the

following user height conditions:

Neck worn – minimum user height 4ft 6in (137cm)

Waist worn – minimum user height 5ft (153cm)

A reduction in performance may be experienced

with users below these heights.

NB: Fall detector option is disabled from the factory. To enable

and or disable fall detection please refer below

 Press and hold the button for 10 seconds to go into

program mode.

 Entering program mode there will be 3 beeps and

the lights will constantly flash yellow.

 After 5 seconds if no action is taken it will drop out of

program mode, back into normal operation mode

 If however the button is pressed again 3 times within 5

seconds of entering program mode then the status of the

Fall Detection will toggle and 2 beeps will be given, and it

will immediately go back to normal mode.

 Enabled: If Fall Detection is enabled after this sequence

then the green light will turn on for 2 seconds.

 Disabled: If Fall Detection is disabled after this sequence

then the red light will turn on for 2 seconds.