Installation Instructions

FCC Warning
This device complies with part 15 of the FCC rules.
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
·Increase the separation between the equipment
and receiver.
·Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
·Consult the dealer or an experienced radio/TV
technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance
requirements, this grant is applicable to only mobile
configurations. The antennas used for this
transmitter must be installed to provide a separation
distance of at least 20cm from all persons and must
not be co-located or operating in conjunction with
any other antenna or transmitter.