User's Manual

Page 13 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
MAIN On/Off Off All off
Scene button On Scene members
are on
Button Taps
Button Type Button LED State
before Tap
Effect of Tap Effect of Double-tap
Toggle Off Turn scene On Turn scene members on instantly
Toggle On Turn scene Off Turn scene members off instantly
Always On Either Turn scene On Turn scene members on instantly
Always Off Either Turn scene Off Turn scene members off instantly
Note: The connected light(s) will react just like the scene responders to button presses of MAIN On/Off (when in 8-
button configuration) and ON or OFF (when in 6-button configuration).
1) The LED will mimic the on/off status of a dimmer whose scene level is 100% bright.
2) The ON button on a 6-button Keypad is an “Always On” button while the OFF button is an “Always Off” button.
Other buttons are toggle by default.
Button Press and Holds
Button Type
Button LED
before Tap
Effect of First
Press and Hold
Effect of Subsequent Press and Holds
Toggle Off
Brighten scene until
release
Opposite of last Press and Hold
(e.g. if last was brighten, it will dim)
Toggle On
Dim scene until
release
Opposite of last Press and Hold
(e.g. if last was brighten, it will dim)
Always On Either Brighten scene until release
Always Off Either Dim scene until release
INSTEON Setup
A scene consists of 1 or more INSTEON devices that respond to 1 or more INSTEON controller(s). When the
scene is activated (turned on), all scene members return to the states they were at when the scene was
programmed. INSTEON scenes let you activate dramatic lighting moods at the touch of a button. For example, you
can set all the lights in a scene to dim to 50% or turn certain lights on while turning others off, all with the tap of a
button on any INSTEON controller. INSTEON scenes are easy to set up: just follow the directions below.
Add Keypad Button to a Scene as a Controller
Follow the steps below to control a scene (one or more INSTEON devices) from a Keypad button.
1) Tap the Keypad button of choice (use ON for 6-button Keypads for “main” scene)
2) Press and hold Keypad’s Set button until Keypad beeps
Keypad’s scene button LED will blink and the Set button LED will blink green.