User's Manual

Page 14 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
3) Adjust the scene responder to the state you want when the scene is activated from Keypad (e.g., 50%, 25%,
off).
10
4) Press and hold the responder’s Set button until it double-beeps (or until its LED/load flashes)
Keypad will double-beep and its scene button and Set button LEDs will stop blinking.
11
Responder’s LED will stop blinking and it may double-beep.
12
5) Confirm that scene addition was successful by tapping on/off on the Keypad scene button
The responder will toggle between the scene’s on level and off
6) If you wish to add more responders to the scene, repeat steps 1-5 for each additional scene responder (or see
Add Multiple Responders to a Scene
).
1
If the responder is a multi-scene device such as a Keypad, tap the scene button you wish to control until its LED is in the desired scene state (on or off).
Remove Keypad Button from a Scene as a Controller
If you are disabling (or removing) any scene responders of Keypad, it is very important that you remove it from the
Keypad scene before disabling if at all possible. Otherwise, delays and error blinks / reports may result. If the
device is not available to disable using this technique please use software to remove it from Keypad.
1) Tap the Keypad scene button (ON for 6-button main scene).
The responder(s) will respond.
2) Press and hold the Keypad’s Set button until it beeps.
Keypad’s scene button LED will blink and the Set button LED will blink green.
3) Press and hold the Keypad’s Set button until it beeps again.
Keypad’s scene button LED will continue blinking and Set button LED will blink red.
4) Press and hold the responder’s Set button until it double-beeps and/or LED blinks.
Keypad will double-beep and its scene button and Set button LEDs will stop blinking.
5) Confirm that Unlinking was successful by tapping the scene button on and off.
The responder will not respond.
6) If you wish to remove multiple responders from Keypad, repeat steps 1-5 for each additional responder (or see
Remove Multiple Responders from a Scene
).
Adding Keypad Button To a Scene as a Responder
1) Press and hold the scene controller button until it beeps.
13
Controller’s LED will blink.
2) Tap the Keypad button you wish to be a responder of the scene at least once.
3) Tap the button again if necessary to get the button’s LED to the desired state for the scene (press and hold if
adding the main scene at a dimmed level).
4) Press and hold Keypad’s Set button until it double-beeps.
Keypad’s scene button LED will flash once and return to previous state.
Controller LED will stop blinking and it will double-beep.
14
5) Confirm that scene addition was successful by tapping on then off on the controller’s scene button.
11
If either the Keypad or responders LED continues to blink, the addition failed. Tap the device’s Set button until LED stops blinking and try again.
12
If either the Keypad or responders LED continues to blink, the addition failed. Tap the device’s Set button until LED stops blinking and try again.
13
If the controller does not have a beeper, wait until its LED begins blinking.
14
Most models