User's Manual

Page 15 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
Keypad button LED will toggle between on and off (and load if main scene).
Removing Keypad From a Scene as a Responder
If you are going to discontinue using Keypad, it is very important that you remove it from all of its scene controllers.
Otherwise, the controllers will resend commands, causing delays and possible error reports.
1) Press and hold the controller’s scene button until controller beeps
15
Controller’s LED will blink.
2) Press and hold the scene button until controller beeps again.
16
Controller’s LED will continue blinking.
3) Tap the Keypad button to remove from scene.
4) Press and hold Set button on Keypad until it double-beeps.
Keypad’s LED will flash once.
Controller’s LED stop blinking.
5) Confirm that unlinking was successful by tapping the button you just unlinked from on the controller.
Keypad will no longer respond.
Advanced Features
Add Multiple Scene Responders
1) Tap the scene controller button on Keypad.
2) Press and hold Keypad’s Set button until it beeps.
Keypad’s scene button LED will blink and Set button LED will blink green.
All illuminated LEDs on Keypad will brighten to 100%.
3) Tap Keypad’s Set button.
Keypad’s scene button and Set button LEDs will continue blinking.
4) For each responder you are adding:
- Adjust the responder to the desired scene state (for Keypads you must tap the button at least once to reach
the desired state).
- Press and hold responder’s Set button until it beeps and/or LED flashes.
Keypad will double-beep.
5) After all responders have been added, Tap Keypad’s Set button.
Keypad’s scene button and Set button LEDs will stop blinking.
Keypad’s LEDs will return to normal brightness.
6) Test scene by tapping the scene button a couple of times.
All the responders added above will respond.
15
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds).
16
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds).