User's Manual

Page 16 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
Remove Multiple Scene Responders
1) Tap the scene controller button on Keypad.
2) Press and hold Keypad’s Set button until it beeps.
Keypad’s scene button LED will blink and Set button LED will blink green.
All illuminated LEDs on Keypad will brighten to 100%.
3) Press and hold Keypad’s Set button again until it beeps again
Keypad’s scene button and Set button LEDs will continue blinking.
4) Tap Keypad’s Set button.
Keypad’s scene button and Set button LEDs will continue blinking.
5) For each responder you are removing:
- If it’s a Keypad button, tap the button.
- Otherwise, press and hold responder’s Set button until it beeps and/or LED flashes.
6) After all responders have been removed, Tap Keypad’s Set button.
Keypad’s scene button and Set button LEDs will stop blinking.
Keypad’s LEDs will return to normal brightness.
7) Test scene by tapping the scene button a couple of times .
All the responders added above will respond.
Synchronized Scenes
Synchronized scenes are scenes where all members stay synchronized. Common examples include 3-way lighting
circuits and scenes with a single load bearing device.
Example: 3-Way Circuit (Circuit with 2 Keypads, A and B)
1) Turn both loads on to the desired (and same) scene level.
2) Press and hold A’s Set button until it beeps.
A’s scene controller button will blink and Set button LED will blink green.
3) Press and hold B’s Set button until it double-beeps.
B’s scene controller button and Set button LED will flash.
A will double-beep and its LEDs will stop blinking.
4) Press and hold Switch B’s Set button until it beeps.
B’s scene controller LED will blink and Set button LED will blink green.
5) Press and hold Switch A’s Set button until it double-beeps (or LED flashes)
A will double-beep and its scene controller button and Set button LED will flash.
B will double-beep and its LEDs will stop blinking.
6) Test the group by controlling the load from A and then B.
The load and A’s and B’s scene controller button LEDs will all remain in synch.
Example: Scene with any number of “N” members
We recommend using home-management software such as HouseLinc to create multi-member synchronized
scenes. However, the following steps, when carefully followed, will also work.