User's Manual
Page 17 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
1) Turn all switches/dimmers on to the desired (and same) scene level.
2) For each switch “X” where X goes from A through N:
a. Press and hold Switch X Set button until it beeps (or LED blinks)
Switch X’s LED will blink.
b. Tap Switch X Set button
Switch X LED will continue blinking.
c. For every other switch in scene, press and hold the Set button until it double-beeps and/or its LED
flashes.
Switch will double-beep and its LED will flash once.
d. Tap Switch X’s Set button.
Switch X LED will beep and its LED will stop blinking.
3) Test the group by controlling the load from each switch.
The load(s) and all switches will remain in synch.
Changing Button Modes (Toggle/Non-Toggle Mode)
You can change any button to any one of 3 button modes (we recommend using home-management software such as
HouseLinc):
Toggle – toggles between on and off commands each time it is tapped
Always On – sends on every time it is tapped
Always Off – sends off every time it is tapped
Note: You cannot change the dedicated ON and OFF buttons in 6-button configuration.
1) Tap the scene button you want to change.
2) Press and hold Keypad’s Set button until it beeps.
The scene button’s LED
will begin blinking and Set button LED will blink green.
All illuminated LEDs on Keypad will brighten to 100%.
3) Press and hold Keypad’s Set button it beeps again.
The button LEDs
will continue blinking.
4) Press and hold Keypad’s Set button until it beeps a third time.
The button LEDs
will stop blinking.
The button function rotates to the next mode in the cycle: Toggle
Always Off
Always On
Toggle.
5) Tap the button several times to confirm it is now in the desired state.
6) If you wish to rotate button mode again, return to step 2.
Adjust LED Brightness
Keypad’s LEDs can be set to any one of 32 brightness levels.
1) Press and hold Set button until it beeps.
Set button LED will blink green.
2) Press and hold Set button until it beeps again.
Set button LED will blink red.
3) Press and hold Set button until it beeps a third time.
Set button LED will blink green.
4) Tap Set button once.
Keypad will beep and Set button LED will double-blink green.