Manualshelf

User's Manual

ManualsBrandsSmartLabs ManualsElectronicsKeypad Dimmer Switch
11121314151617181920
Page 18 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
5) Press and hold Set button.
Keypad will beep and Set button LED will continue double-blinking green.
6) Using the ON (brighten) and OFF (dim) buttons, adjust button LED button brightness to desired state.
7) When satisfied, tap Set button once to save brightness settings.
Keypad will double-beep and Set button LED will stop blinking.
8) To not save your settings after step 5 and return to the previous button LED brightness level, press and hold Set
button.
Keypad
will beep and Set button LED will stop blinking.
Turn Button Beep On or Off
The Keypad buttons can be set to Beep Mode so Keypad will beep every time a button is used. This feature is disabled
by default; to enable it, use home-management software such as HouseLinc.
X10 Setup
Add X10 Address to a Button
1) Tap the Keypad scene button you want to add.
2) Press and hold Keypad’s Set button until it beeps.
Set button LED will blink green.
3) Send the desired X10 Address plus ON 3 times in a row (e.g. send B5-BON-B5-BON-B5-BON).
Keypad will double-beep and the Set button LED will stop blinking.
Remove X10 Address from a Button
If you are no longer going to utilize an X10 address associated with Keypad, it is very important that you remove its
X10 address. Otherwise, Keypad will still listen for X10 commands (somewhat hindering INSTEON reception) and
may respond to spurious X10 “noise” which is unavoidable. Furthermore, Keypad will transmit an X10 address and
command every time the button is pressed.
1) Tap the Keypad button.
2) Press and hold Keypad’s Set button until it beeps.
Set button LED will blink green.
3) Press and hold Keypad’s Set button again until it beeps again
The button’s LED will continue blinking red.
4) Send the X10 Address plus ON 3 times (e.g. send B5-BON-B5-BON-B5-BON).
Keypad will double-beep and the Set button LED will stop blinking.
Advanced X10 Programming
Instructions on setting X10 primary address and scene addresses can be found online:
http://www.smarthome.com/insteon-x10-programming.html