User's Manual

Page 21 of 60 2334-2xx- Rev: 12/13/2012 1:54

create an air gap.

To restore power, press the air gap back into place until its top is even with the trim frame.

Beep on Button Press

Default = Off

This setting is adjustable via software or a central controller only.

Error Blink

Default = on

This setting is adjustable via software or a central controller only. Keypad Dimmer LED blinks red for a few seconds

if one or more responders do not acknowledge a message.

Changing to 6-Button or 8-Button Plate

- The 6-button plate provides a dedicated load ON button at the top of the switch, a dedicated load OFF button

at the bottom, and four programmable secondary buttons between the On and Off buttons

- The 8-button plate provides a dedicated load MAIN On/Off button in the top left-most position of the keypad

and seven programmable secondary buttons.

Attach the change-out plate to the switch body by aligning the tabs. Snap into place.

Note:

For proper operation, Keypad must be programmed to operate in 6-button or 8-button mode, corresponding to

whichever plate is attached. See Configuring for 6 or 8-Button Operation

Changing Buttons

Keypad buttons can be swapped out with custom-etched buttons to customize its

appearance. Using a small, flat-edged screwdriver only, carefully pry up on the sides

of the keys from the middle of the keypad (when possible). Make sure you are

centered on the key so as to catch the small edge located there for this purpose.