Manualshelf

User's Manual

ManualsBrandsSmartLabs ManualsElectronicsKeypad Dimmer Switch
11121314151617181920
Page 22 of 60 2334-2xx- Rev: 12/13/2012 1:54
PM
Please note that behind the buttons are clear plastic filler pieces; these diffuse the the buttons’ LEDs’ lights more
elegantly. Use care to keep these filler pieces in the button frame as you reassemble the keypad.
Should any damage occur to Keypad during customization, please contact 800-762-7845 and we will be happy to replace
your frame.
ADVANCED FEATURES
Local Ramp Rate
The local ramp rate is the time it takes for the light(s) physically wired to Keypad to brighten from full-off to 100%
brightness. The default ramp rate is 0.5 seconds, but it can be set to different rates. When set manually, you can change
the ramp rate to one of four different levels. However, when using home-management software such as HouseLinc, the
ramp rate may be configured anywhere from 0.1 seconds to 8 minutes. Follow the instructions below to manually change
the local ramp rate:
1) Press and hold Set button until it beeps.
Set button LED will blink green.
2) Press and hold Set button until it beeps again.
Set button LED will blink red.
3) Press and hold Set button until it beeps a third time.
Set button LED will blink green.
4) Press and hold Set button until it beeps a fourth time.
Set button LED will blink red.
5) Tap Set button once.
Keypad will beep and Set button LED will double-blink red.
6) Tap Set button again.
Keypad will beep and Set button LED will blink red.
7) Press and hold Set button until it beeps.
Set button LED will continue blinking red.
8) Using the ON (brighten) and OFF (dim) buttons, adjust load to the brightness level corresponding with your desired
ramp rate:
Load Brightness Level Ramp Rate in Seconds
100% (full-on) 0.1
50%-99% 0.5
1%-49% 1
0% (full-off) 2
9) When satisfied, press and hold Set button to save local ramp rate settings.
Keypad will double-beep and Set button LED will stop blinking.
10) Note: when using HouseLinc or other home-management software, you can set local on-levels and ramp rates
consistently for multiple devices throughout your home.