User's Manual

ManualsBrandsSmartLabs ManualsElectronicsTriggerLinc

Page 2 of 1

Rev. 111408

For HELP, call our friendly tech support @ 1-800-SMARTHOME (800-762-7846)

SmartLabs Limited Warranty – SmartLabs warrants to the original consumer of this product that, for a period of two years from the date of purchase, this product will be free from defects in material and

workmanship and will perform in substantial conformity to the description of the product in the owner's manual and/or quick start guide. This warranty shall not apply to defects or errors caused by misuse

Factory Reset

1) If possible, unlink from all responders before proceeding

2) Remove battery

3) Wait 15 seconds

4) While pressing & holding the Set button, re-attach the battery and continue holding the Set button for 3 seconds until the LED turns on for a few seconds.

TriggerLinc’s LED will turn on for a few seconds and then turn off

Optional: Wired Sensor

1) Remove cover on TriggerLinc main case

2) Connect wires to sensor

3) Store magnet for potential future use

Advanced: Multi-Scene Control

By default TriggerLinc will turn a Scene On when sensor is opened and Off when the door/window is closed. Alternatively, by moving the jumper to the “off” position,

TriggerLinc can send an On to “Scene 1” when the door/window opens and an Off to “Scene 2” when the door/window closes.

1) Remove jumper (from both pins) and replace on only one pin

2) Open door/window

3) Link to Scene 1 Responders (s) (these responders will turn on when door/window is opened)

4) Close door/window

5) Link to Scene 2 device(s) (these responders will turn off when door/window is closed)