User's Manual

Page 12 of 25 Rev: 3/1/2012 3:06 PM

press of Time / Sensor:

 Clock Format setting (12 or 24 Hr clock)

 Entire “time” sections blinks

 Up / Down cycles between 12 and 24 Hr clock format

Note: AM / PM are not displayed when in 24 Hour format

TempLinc Zone Thermostat Program Button Operation

- The Program button allows you to setup the various pre-programmed modes (Wake, Leave, Return,

and Sleep).

- Go to the next Program step by pressing Program again

- Exit Program setup by:

 Time out 30 seconds

 Pressing any button other than Up, Down or Program

IMPORTANT! Once you have Added TempLinc Zone Thermostat to a Scene in TempLinc Thermostat as

a wireless temperature zone, the Program and Time / Sensor buttons will no longer function. All program

and time controls will be performed on the TempLinc Thermostat.

Note: Colors indicate element that is presently blinking during setting procedure

press of Program:

 Selects from available pre-program modes

 Up / Down cycles through Wake, Leave, Return, and Sleep

Note: Energy is not a part of this option

Note: Once a pre-programmed mode is selected, that item remains displayed throughout to

indicate what you are programming

Note: Once a pre-programmed mode is selected, the current settings are displayed on TempLinc Zone

Thermostat

press of Program:

 Start Time

 Up / Down cycles through time in 15 minute increments

 Press and hold of Up / Down cycles faster

Note: AM / PM changes automatically as needed

Note: The start of one program mode is also the end of the previous program mode