User's Manual

Page 13 of 25 Rev: 3/1/2012 3:06 PM
3
rd
press of Program:
 Cool setpoint
 Up / Down cycles through temperature
4
th
press of Program:
 Heat setpoint
 Up / Down cycles through temperature
5
th
press of Program:
- Starts the process all over again to program another Mode
Note: The 4 modes come pre-programmed. The defaults are:
4 Day Modes Start Time Thermostat Mode Heat Setting Cool Setting
Wake 6AM Auto 65 75
Leave 8:30AM Auto 60 80
Return 5:00PM Auto 65 75
Sleep 11:00PM Auto 60 80
Note: To exit mode press Mode button once
TempLinc Zone Thermostat Fan and Hold Button Operations
Fan button operations
- The Fan button cycles between Auto and Always On.
- On the display, it simply indicates the text “Fan Always” when selected. No indication for “Auto”.
Hold button operations
- The Hold button over-rides a pre-programmed mode until Hold is turned off:
Note: While the hold is enabled, when the next pre-programmed time comes in Programmed Auto
Mode it will be ignored
Note: While hold is enabled, the Programmed Auto time notations are not shown
(i.e. Wake, Leave, Return and Sleep)