User's Manual

Page 17 of 25 Rev: 3/1/2012 3:06 PM
Add to a Scene Process:
1) Press & hold TempLinc Zone Thermostat Set button until it beeps
TempLinc Zone Thermostat Set LED blinks GREEN
TempLinc Zone Thermostat will (Beep)
2) Tap:
 Up or Down buttons to select Group 1 – 4 to Add to a Scene
 Group 1 - Cooling mode change, default
 Group 2 - Heating mode change
 Group 3 – De-humidification, high humidity setpoint
 Group 4 - Humidification, low humidity setpoint
3) Adjust Scene Responder, such as OutletLinc with connected humidifier, to the “state” you want when
Scene is activated (e.g., 50%, 25% or even OFF)
Upon entering Scene mode this screen will display for ~ 2 seconds
LCD display if press Up button or after 2 seconds
LCD display when using Up or Down buttons to select from among the 4 Controller Groups
4) Press and hold Responder’s Set button