User's Manual

Page 18 of 25 Rev: 3/1/2012 3:06 PM
TempLinc Zone Thermostat will (Beep)-(Beep) upon completion
LED returns to previous state
Removing TempLinc Zone Thermostat as a Controller
1) Press & hold TempLinc Zone Thermostat’s Set button until it beeps
TempLinc Zone Thermostat Set LED blinks GREEN
TempLinc Zone Thermostat will (Beep)
2) Press & hold TempLinc Zone Thermostat’s Set button again until it beeps
TempLinc Zone Thermostat Set LED blinks RED
TempLinc Zone Thermostat will (Beep)
LCD display indicates the group that you are removing Scene from
3) Tap:
 Use Up and Down buttons to select appropriate Group to remove from:
 Group 1 - Cooling mode change, default
 Group 2 - Heating mode change
 Group 3 - Dehumidifiation, high humidity setpoint
 Group 4 - Humidification, low humidity setpoint
Upon entering Add a Scene mode
Upon entering Remove a Scene mode
Defaults to Cooling mode