User's Manual

Page 21 of 25 Rev: 3/1/2012 3:06 PM
- Sub-mode 01: Display LED on-time select (Default is 10 seconds)
- Sub-mode 02: Humidity Low Set Point (Default is 30%)
- Sub-mode 03: Humidity High Set Point (Default is 50%)
- Sub-mode 4: Temperature format select (Default is Fahrenheit)
- Sub-mode 5: Beep on button press (Default is Off)
- Sub-mode 6: Status LED (Default is On)
- Sub-mode 7: Button Lock (Default is Off)
- Sub-mode 8: Programming lock (Default is Off)
- Sub-mode 9: Activation Delay (Default is 10 minutes)
2) Press the Up or Down button to change a setting
 Sub- mode 01: LED Backlight on time, 10 seconds default
a. Up button = 5 second increments longer
b. Down button = 5 second increments shorter
c. Options:
o Off always
o On for 5 – 95 seconds in 5 second increments
o On always
 Sub-mode 02: Humidity Low Set Point (humidification), 30% default
a. Up button = Increase humidity % setpoint
b. Down button = Decrease humidity % setpoint
 Sub-mode 03: Humidity High Set Point (dehumidification), 50% default
c. Up button = Increase humidity % setpoint
d. Down button = Decrease humidity % setpoint
 Sub- mode 04: Temperature format select (C or F), F default
e. Up button = C
f. Down button = F
 Sub-mode 05: Beep on button press (Enable / Disable), Off default
b. Up button = On
c. Down button = Off