User's Manual

Page 8 of 25 Rev: 3/1/2012 3:06 PM
TempLinc Zone Thermostat Sample
The gray buttons
shown here are
under the door
of the TempLinc
Zone
TempLinc Zone Thermostat Button Overview
1) Up/Down adjusts the temperature setpoint based on the mode you are currently in
2) Mode allows the user to select the current operational mode of the HVAC system. It cycles
between Off, Heat, Cool, Auto, and Programmed Auto.
3) Energy button is designed as a quick access option that saves energy (and money). When
pressed, it will setback the setpoint by a specified value. The default value is 4 degrees from the
current setting. To change the default offset value to be a value other than 4 degrees, you must
use software, such as HouseLinc.
4) Hold over-rides a pre-programmed mode
5) Fan cycles between Auto and Always On – no indication given for “Auto Fan”
6) Master makes this device the master temperature controller. Pressing “Master” does not alter any
scene or screen settings. It just defines this TempLinc Zone Thermostat as the master
temperature controller.
7) Time / Sensor button allows you to set the date and time. It cycles between hour, minute, and
time format.
8) Program button allows you to setup the various pre-programmed user modes
9) Set button is for INSTEON Add to and Remove from Scenes with a TempLinc Thermostat and
other INSTEON devices. It functions like Set does for other INSTEON devices.
2
1
4 5 6 7 8 9 3