User's Manual

Page 9 of 25 Rev: 3/1/2012 3:06 PM
TempLinc Zone Thermostat Operation and Programming
Thermostat Mode Button Operation
Off Mode:
 No setpoints are shown
 Up / Down do not do anything
Heat Mode:
 Only Heat setpoint is shown
 Up / Down changes the Heat setpoint
Cool Mode:
 Only Cool setpoint is shown
 Up / Down changes the Cool setpoint
Auto Mode:
 Both cool and heat setpoints are shown
 Up / Down move both together with a
set gap
Programmed Auto Mode:
 The program mode is active in this mode
(Return annotation)
 It is not in the other 4 modes (Off, Heat,
Cool and Auto)
 Both Cool and Heat setpoints are shown
 Up / Down move both together with a set
gap
 When the thermostat moves to the next
time period, the setpoints will be adjusted
accordingly
Note: To adjust gap between the setpoints in auto mode, press mode to select Heat and set the
temperature you desire. Then press mode to select Cool and set the temperature you desire.
Press Mode button to return to Auto and the settings will reflect your changes.
Note: If you set the Heat and Cool to the same temperature, Heat will automatically be moved down 2
degrees which is the minimum allowable gap.