User's Manual

Page 10 of 25 Rev: 3/1/2012 3:06 PM
TempLinc Zone Thermostat Energy Button Operation
The Energy button is designed to be a very quick to use option that saves energy (and money). When
you press the Energy button (identified with the leaf), TempLinc Zone Thermostat will setback the set
points by a specified value. The default value is 4 degrees from the current setting. To change the default
offset value to be a value other than 4 degrees, you must use software.
- When you exit Energy mode, it will revert back the 4 degrees that was changed upon entry
- The unit remains in Energy mode until the Energy button is pressed again
- Up / Down adjust the temperature set point based on the mode you are in
From Off Mode:
 Energy button does nothing because the
system is off (at maximum energy savings
already)
 When “Energy” appears on the screen for
Auto, Cool and Heat Modes, the 4 degree
setback is engaged
From Heat Mode:
 Heat sets back as specified
 Default setback is 4 degrees
Notice that “Heating” is active on the left, but
not on the right; the element reads “Heat”.
From Cool Mode:
 Cool sets back as specified
 Default setback is 4 degrees
From Auto Mode:
 Both Heat and cool setpoints setback as
specified
 Default setback is 4 degrees
Notice that “Heating” is active on the left, but
not on the right; the element reads “Heat”.