User's Manual

Tips for Using AccessLinc

• Do not plug AccessLinc into a power strip or AC line filter.

• Some computers, audio-video products, and their acces-

sories can absorb Power Line Carrier (PLC) signals off the

power lines. If the AccessLinc is electrically near these

devices, they should be filtered. Use Smarthome’s

FilterLinc #1626 on this equipment to keep the Insteon

powerline signals from getting absorbed.

• Don't plug other PLC transmitters into the same outlet as

the AccessLinc. Every PLC transmitter will absorb the

other transmitter's PLC signals when they are not trans-

mitting. In some cases, up to half the signal can be lost

nearby transmitters.

• The AccessLinc is not designed nor approved for use on power lines that on

something other than 120V/60Hz cycles. Attempting to use the AccessLinc on

non-approved power-lines may have hazardous consequences.

• Due to the size of AccessLinc, it will block the bottom outlet of a duplex wall

receptacle if plugged into the top outlet. If possible, use the bottom outlet so

that the other outlet is accessible for other use. For convenience, a pass

through receptacle has been supplied on the AccessLinc so you don’t lose a

receptacle.

• If the AccessLinc is plugged into a receptacle controlled by a wall switch, consid-

er leaving the switch on at all times. This will ensure that the AccessLinc never

loses power and is always functioning. Never plug the AccessLinc into an outlet

controlled by a dimmer.

• Never stack another Smarthome automation module like LampLinc,

ApplianceLinc, or PowerLinc. The internal heat generated when controlling a

load may cause them to overheat, catch fire, or lockup and stop functioning.

• When installed in pairs, the antenna direction needs to be the same. If one

antenna is vertical and another is horizontal, range and reliability will be

reduced.

• Do not place AccessLinc near large metal objects, like a refrigerator, cabinet, or

television. AccessLinc works best when placed out in the open.

• If interference from AccessLinc is heard on 900MHz cordless phones, move to a

different frequency or channel on the cordless phone. Exact procedures vary

from brand-to-brand; please see your cordless phone instructions.

#1626 FilterLinc

Plug-In Filter

2442 July 15,04_web.qxd 7/15/2004 10:59 AM Page 6