User's Manual

Page 6 of 32 2474DWH- Rev: 3/6/2012 10:13 AM
Installation
1) At electrical panel, turn off circuit breaker(s) feeding wall box (verify that power is off)
2) Remove wallplate and unscrew the switch you are replacing and gently pull out
3) Disconnect wires from switch
1
4) Turn breaker on
5) Use a voltage meter to identify the line and load wires which connected to the switch
6) Identify ground
7) Turn breaker back off
8) Connect wires
SwitchLinc Wire Wall Box Wire (common colors)
Bare copper Ground (bare copper, green wire or green screw)
Red Light / load (red or blue)
Black Line (black)
9) Gently place SwitchLinc into wall box, oriented with the LED bar on left and screw into place
10) Turn breaker on
Light will turn on
LED turns white and indicates brightness of light
11) Verify SwitchLinc is working properly by turning the light on and off
12) Reinstall the wallplate
1
If the wires cannot be detached by unscrewing them, cut the wires where they enter the switch, then strip ½” of insulation off the ends