User's Manual

Page 8 of 32 2474DWH- Rev: 3/6/2012 10:13 AM

Change LED Brightness (or turn it off)

1) Press & hold SwitchLinc set button until it beeps (3 seconds)

SwitchLinc LED will begin blinking green

2) Press & hold set button until it beeps again (3 seconds)

SwitchLinc LED will start blinking red

3) Press & hold set button until it beeps a third time (3 seconds)

SwitchLinc LED will stop blinking

SwitchLinc Status LED will illuminate at current LED brightness level

4) Use the paddle to brighten or dim the LEDs to desired brightness

a. Press & hold paddle top to brighten

b. Press & hold paddle bottom to dim

5) Once you have reached the desired brightness for your LEDs, tap set button once

SwitchLinc will beep

LED’s now set to new brightness level

INSTEON Setup

INSTEON Controllers, Responders and Links

Let’s define a few terms.

 The INSTEON “transmitter” is called a Controller

 The INSTEON “receiver” is called a Responder

 The association between the controller and responder is called a Link

Please note that a link is one way. If you wish to have control “the other way”, simply repeat link setup process “the

other way”. Most INSTEON devices can store hundreds of links. Furthermore, a controller can simultaneously

control from 1 to hundreds of responders using what are called groups and scenes. Each link can have its own

properties (e.g. 50% brightness at a 4 second ramp rate).

Make SwitchLinc a Responder

Follow the steps below to create a link, enabling another INSTEON device to control SwitchLinc.

1) Press & hold controller button until beep (or LED blinks)

Controller LED will start blinking

2) Adjust SwitchLinc to desired brightness / state for link

Load turns on and LED turns white

3) Press & hold SwitchLinc set button until double-beep

Controller will (beep)-(beep) & LED stops blinking

4) Test by tapping controller button on and off

SwitchLinc will turn on and off

Notes:

- The link just created is one-way, see “Make SwitchLinc a Controller” to add another link to keep the two

products in synch.

Controller

Res

onder

Link

Controller

SwitchLinc

(Responder)

Link