User's Manual

Page 10 of 32 2474DWH- Rev: 3/6/2012 10:13 AM
7) Test by tapping controller button on and off
SwitchLinc and other scene responders will all respond appropriately
Add Multiple Responders
1) Press & hold SwitchLinc set button until beep
LED will start blinking green
2) Tap SwitchLinc set button
LED will start double-blinking green
3) For each responder you are adding
- adjust responder to desired link/scene state
- press & hold set button until double-beep (or LED flashes)
4) Press SwitchLinc Set button once
SwitchLinc will beep once
LED stops blinking
5) Test by tapping the SwitchLinc on and off
All the responders will turn on and off
Stop SwitchLinc from Responding to an INSTEON Controller
If you no longer want a controller button to control SwitchLinc follow these directions. Note: If you ever wish to un-
install SwitchLinc, it is important that you remove all SwitchLinc responder links. Otherwise, controllers will retry
commands repetitively, creating network delays.
1) Press & hold controller button until beep
3
LED will start blinking green
2) Again, press & hold controller button until beep
LED will start blinking red
3) Press & hold SwitchLinc set button until double-beep
Controller LED stops blinking
4) Test by tapping controller button on and off
SwitchLinc will no longer respond
Stop SwitchLinc from Controlling an INSTEON Responder
If you no longer want SwitchLinc to control another device (or are removing SwitchLinc) it is important that you
follow the instructions below for each responder.
1) Press & hold SwitchLinc set button until beep
LED will start blinking green
2) Again, press & hold SwitchLinc set button until beep
LED will start blinking red
3) Press & hold responder set button until double-beep (or LED blinks)
SwitchLinc will (Beep)-(Beep) and LED stops blinking
4) Test by tapping SwitchLinc on and off
Responder will not respond
Stop SwitchLinc from Controlling Multiple INSTEON Responders
1) Press & hold SwitchLinc set button until beep
LED will start blinking green
2) Again, press & hold SwitchLinc set button until beep
LED will start blinking red
3) Tap SwitchLinc set button
LED will start double-blinking red
4) For each responder you are removing
3
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)