User's Manual

Page 7 of 14 2475DA1 - Rev: 4/20/2012 4:35 PM
NOTE:
If In-LineLinc Dimmer Dual-Band’s Status LED is blinking, you held the Set button down too long and
accidentally placed it into linking mode, which times out after 4 minutes of inactivity. To manually exit
linking mode, tap any button except Set button.
Beeper Behavior
The In-LineLinc Dimmer Dual-Band features a built-in beeper which aids in programming and can also be
used as an indicator via compatible software controllers. Here are the different beeping behaviors and
what they mean:
- Single beep: Transition from one setup mode to another
- Double-beep: Successful link or unlink
- Continuous beeps for 3 seconds: unsuccessful link or 4-minute setup timeout
- Continuous beeps for 10 seconds: warning prior to a factory reset
Setting Up an INSTEON Scene
INSTEON remote control is done using scenes. Scenes allow you to instantly activate favorite lighting
and appliance settings at the touch of a button (or in response to a command from a central controller or
sensor). Each scene has at least one controller and at least one responder linked to one another. Simple
scenes can be set up using the instructions below. Software such as HouseLinc is recommended for
setup of larger scenes.
Adding In-LineLinc Dimmer Dual-Band to a Scene as an INSTEON Responder
1) Use the ON/OFF buttons on In-LineLinc Dimmer Dual-Band to adjust the load to the state you wish to
activate from the controller .
2) Press and hold the scene controller button until it beeps.
1
Controller’s LED will blink.
3) Press and hold the Set button on In-LineLinc Dimmer Dual-Band until it double-beeps.
Controller will double-beep
2
and its LED will stop blinking.
4) Confirm that scene addition was successful by toggling the controller’s scene button on and off.
Light should go to the level you defined in step 2.
Removing In-LineLinc Dimmer Dual-Band from a Scene as an INSTEON Responder
If you are going to uninstall In-LineLinc Dimmer Dual-Band, it is very important that you remove it from all
of its scene controllers. Otherwise, controllers will experience delays and may produce flashing error
indications.
1) Press and hold controller’s scene button until controller beeps.
3
Controller’s LED will blink.
2) Press and hold Controller’s scene button until controller beeps again.
3
Controller’s LED will continue blinking.
3) Press and hold Set button on In-LineLinc Dimmer Dual-Band until it double-beeps.
Controller will double-beep
2
and its LED will stop blinking.
4) Confirm scene removal was successful by tapping the button on the controller with the scene you just
removed.
In-LineLinc Dimmer Dual-Band will no longer respond.
1
If the controller does not have a beeper, wait until its LED begins blinking
2
Most models
3
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)