User's Manual

Page 11 of 12 2475DA2 Rev: 11/10/2011 9:41 AM
Tro hootinubles g
Problem Possible C ution ause Sol
Make sure the circuit breaker is turned on.
The Status LED
LineLi
o
nc is not turning
on and won’t con
the load.
Check the junction box wires to ensure all
no bare wires are
n In-
trol
In-LineLinc may
getting power.
not be
connections are tight and
exposed.
The controller might have
king In-Line
oller.
been reset witho
Unlin
ut
Linc from
Re-Link In-LineLinc to the contr
it.
The INSTEO
be too weak.
N signal may
Add additional INSTEON devices or move around
existing INSTEON devices. All INSTEON devices
aters. act as INSTEON network repe
Large applianc
refrigerator
conditioners
producing electri
on the powe
es
s or air
, may be
cal noise
r line.
, such as
In-LineLinc won’t
or work with a
controller.
l d
mpute
o
b
sig
1626-10) to filter
nal attenuation.
link
Other electrica
such as co
televisions, or p
strips, may be a
the INSTEON
evices,
rs,
wer
electrical noise and minimize si
sorbing
nal.
Install a power line noise filter (#
g
Unlink any unused responders from the controlle
HINT: If you are using home aut
you can easily c
r.
omation software,
heck scene membership and
eliminate unnecessary links.
In-LineLinc is tak
a
an
sponder that is
longer in use. Commands
re
t
down the
rm a factory reset
ing a
The controller m
sending comm
re
long time to respond
to a controller.
y be
ds to a
no
for the unused
are being resen
loading
sponder
and
signal.
If the above doesn’t work, perfo
on the controller.
The load turned on by
itself.
Another controller or timer
could have trigge
e Resetting In-LineLinc
gs.
red In-
Perform a factory reset. Se
to its Factory Default Settin
LineLi
nc.
The controller can
off In-LineLinc but In-
command from the
controller.
Re-link In-LineLinc to the controller, while the load
ontroller to In-
LineLi
nc.
turn
LineLi
nc does not turn
on when I send an ON
In-LineLinc may be linked
at its off state.
is on. See Linking an INSTEON C
Temporarily remove power from In-LineLinc,
usually by opening the breaker feeding it.
In-LineLinc is locked
up.
A surge or excessive
noise on the power line
may have glitched it.
If the above doesn’t work, perform a factory reset.
See Resetting In-LineLinc to its Factory Default
Settings.
If you have tried these solutions, reviewed this Installation and Programming Guide, and still cannot
resolve an issue you are having with In-LineLinc, please call:
The INSTEON Gold Support Line
800-762-7845