User's Manual

Page 6 of 12 2475DA2 Rev: 11/10/2011 9:41 AM
Installing In-LineLinc in Dual Relay Mode
1) Be sure to write down the INSTEON ID and location of the fixture you’ll be controlling
ture, and then verify
need to install a KeypadLinc 277V Controller (model 2487s) at the wall box that originally
wire from the
e load and wire nut it
c and the In-LineLinc
sure that
RAL wires on In-
ore connecting them.
nnectors are firmly attached and that
he fixture, turn on circuit breaker supplying power to the KeypadLinc and In-
nd Off button on In-LineLinc to test that it is controlling the load
10) Link In-LineLinc to the KeypadLinc or any other desired INSTEON devices. See Adding In-LineLinc to
2) At the circuit breaker or fuse panel, disable the circuit supplying power to the fix
the power is off
3) You will
controlled the fixture. Wire the KeypadLinc to line and Neutral but cap the red Load
KeypadLinc.
4) Take the existing switch leg from the wall box that supplied switched power to th
with the line on the KeypadLinc. This supplies constant HOT to both KeypadLin
at the same time
5) At the Ballast location, disconnect the wires from the fixture you will be controlling and en
you have ½ inch of bare wire on the ends
6) See the diagram below to identify and connect the LINE, LOAD1, LOAD 2 and NEUT
LineLinc. Be sure you have correctly identified the wires in the junction box bef
7) After you have connected all the wires, ensure that the wire co
there is no exposed copper
8) Prior to reinstalling t
LineLinc
9) Use the On a
a Scene as a Responder.
11) Gently place In-LineLinc into the fixture box, making sure nothing could accidentally press on the
buttons on its face
13) Reinstall the fixture
Diagram showing
only the non-
dimming
connection to
ballast 1 and 2.
The Hot feeding
this circuit is
paralleled from the
Hot connection on
the KeypadLinc
keeping both
devices HOT at all
times