User's Manual

Page 7 of 12 2475DA2 Rev: 11/10/2011 9:41 AM
INSTEON Programming
Links made between devices are called Scenes. The Scenes can contain 1 or 100+ devices
Adding In-LineLinc to a Scene as a Responder
1) Use the On and Off button on In-LineLinc to set the load to the state you wish to activate from the
controller activates the scene, etc.)
2)
3)
ouble-beeps
Controller will (Beep)-(Beep) and its LED will stop blinking
ing On then Off on the controller’s scene button
controlle
r (turn it on if you wish it to be on when the
Press & hold the scene controller button until it beeps
1
Press & hold the Set button on In-LineLinc until it d
In-LineLinc's Status LED will flash once and then turn on steady
2
4)
Confirm that scene addition was successful by tapp
The In-LineLinc will respond appropriately
Removing In-LineLinc from a Scene as a Responder
very important that you remove it from all of its
scene elays.
ss & hold the controller’s scene button until controller beeps
3)
eLinc until it double-beeps
The In-LineLinc Status LED will flash once and then turn on bright if the load if off or dim if the
4) Confirm that Unlinking was successful by tapping the button you just Unlinked from on the controller
If you are going to discontinue using In-LineLinc, it is
controllers. Otherwise, the controllers will retry commands repetitively, creating network d
1) Pre
3
2)
Press & hold the controller’s scene button until controller beeps again
3
Press & hold the Set button on In-Lin
load is on
In-LineLinc will no longer respond
Advanced Features
Us g In tion Mode)
s in your home (via communications with dual-band
device ridged via In-
LineLinc:
Mode by tapping the Set button on In-LineLinc four times quickly
Other dual-band devices' LEDs will illuminate at 100% brightness
2) Check the LED behavior of the “other” dual-band devices
- If the “other” dual-band device is blinking green
4
i. it is within range and not on the same phase, proceed to next Step
in -LineLinc as a Phase Bridge ( hase Bridging DetecP
In-LineLinc automatically bridges the electrical phase
s on the “other phase”). Use the following procedure to confirm that phases are b
1) Start Phase Bridging Detection
In-LineLinc will begin (Beeping)
1
If the controller does not have a beeper, wait until its LED begins blinking
2
Most models
3
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)
4
Or is simply blinking for single colored LEDs. If the “other” dual-band device is a KeypadLinc Dual-Band, the 4 middle LEDs will blink.