User's Manual

Page 8 of 12 2475DA2 Rev: 11/10/2011 9:41 AM
- If they are not blinking green
1
i. Try moving the “other” device, check other dual-band devices or begin
test from a different initiator
3)
g and LED returns to previous state
Other devices’ LEDs will stop blinking
Tap In-LineLinc’s Set Button
In-LineLinc will stop beepin
Restoring Power to In-LineLinc
n-volatile memory.
tings are saved in this non-volatile memory, they will not be lost in the event of a power
failure.
ally return the load to the state it had before power
In-LineLinc stores all of its settings, such as links to other INSTEON devices, with no
Because set
In the event of a power loss In-LineLinc will automatic
was interrupted.
Resetting In-LineLinc to its Factory Default Settings
The factory reset procedure clears all settings from In-LineLinc, including INSTEON links, X10 addresses,
.etc
Option 1
1) ossible, remove all scene mIf p emberships prior to performing the factory reset.
3) Press & hold the In-LineLinc’s Set button until it beeps again
In-LineLinc’s LED will blink red
t button, then immediately press & hold it until the long beep stops
Option 2 –
2) ss & hold the Set button on In-LinPre eLinc until it beeps
LED will blink green
4) Double-tap the Se
In-LineLinc’s LED will turn off
In-LineLinc will emit a long ((((((Beep))))))
two people required
1) If possible, remove all scene memberships prior to performing the factory reset.
3) While Pressing & holding In-LineLinc’s Set button, have a friend turn the circuit breaker back on
As you continue to press & hold, In-LineLinc will (Beep)
4) Continue to press & hold the Set button for 3 seconds, then release
As soon as you release the Set button, the In-LineLinc LED will turn on solid green and
then dim. After a few seconds, In-LineLinc will (Beep)-(Beep).
2) Turn circuit breaker off
1
Or are not blinking at all for single colored LEDs. If the “other” dual-band device is a KeypadLinc, any LEDs that are on will go to full bright.