User's Manual

Page 6 of 13 Rev: 12/7/2011 3:09 PM
in the notches on the FanLinc case; ensure that cable tie and wires will not interfere with any moving
parts.
INSTEON Scenes
Scene: One or more INSTEON responders (like FanLinc) which respond to an INSTEON controller. When
the scene is activated (turned “on”), all devices return to the states they were at when the scene was
programmed.
INSTEON scenes let you activate dramatic lighting moods at the touch of a button. For example, you can
set all the lights in a scene to dim to 50% and have the ceiling fan spinning slowly, all with the tap of a
button on any INSTEON controller. INSTEON scenes are easy to set up, just follow the directions below.
Add FanLinc’s Light to a Scene as a Responder
Follow the steps below to add your light to an INSTEON scene.
1) Press & hold the scene controller button until it beeps
1
Controller’s LED will blink
2) Tap FanLinc’s Light Set button until the connected light is on
Light’s LED will be GREEN
3) Press & hold FanLinc’s Light Set button until FanLinc double-beeps
Light’s LED will flash once & return to GREEN
Controller will (Beep)-(Beep)
3
and its LED will stop blinking
4) Make sure the fan’s lights are connected to the assembly, confirm that the scene addition was
successful by tapping On / Off on your scene controller
The Light Connected to FanLinc will toggle between On and Off
5) If you wish to adjust the light’s scene On-Level and/or Ramp Rate
Adjusting Ramp Rate:
a. Using your Scene Controller, adjust the light’s brightness to correspond with the ramp
rate desired (Ramp Rates)
b. Double-Tap FanLinc’s Fan Set Button
c. Return to step #1 above
Adjusting On-Level:
a. Using your scene controller, adjust the light’s brightness to the desired brightness for
your scene
b. Return to Step #1
6) If you wish to add FanLinc’s light to more scenes, simply repeat these steps
Add FanLinc’s Fan to a Scene as a Responder
Follow the steps below to add your ceiling fan to an INSTEON scene.
1
If the controller does not have a beeper, wait until its LED begins blinking
3
Most models