User's Manual

Page 8 of 13 Rev: 12/7/2011 3:09 PM
5) Temporarily hang the fan from the mounting ring so the fan can spin safely and without obstruction.
Then while safely clear of the fan blades press On / Off on your scene controller
6) Confirm that Unlinking was successful by tapping the button you just Unlinked from on the Controller
FanLinc’s LEDs, light and/or fan will no longer respond
NOTE: If you have a controller such as SwitchLinc linked to both the fan and light on FanLinc and you
unlink SwitchLinc from either fan or light, you must re-link to the other feature to have it continue to
control the other feature.
LED and Beeper Behavior
LEDs
Fan LED
Green blink slow Setup: Set scene speed to Slow
Green blink medium Setup: Set scene speed to Medium
Green blink fast Setup: Set scene speed to Fast
Red steady on Setup: Set scene speed to Off
Green steady on Fan is On
Red steady on Fan is Off
Light LED
Blinking Green Setup: Awaiting X10 address
Blinking Red Setup: Awaiting X10 address removal
Green Light is On
Red Light is Off
Beeper
Beeper
Single Beep Enter Setup Mode (or transition to next Setup Mode)
Double-Beep Setup successful, return to Ready Mode
3 Second Beep Return to Ready Mode (either after setup time-out or user-
initiated Set Button Tap)
Fast Beeps On transition to next fan speed
Advanced Features
The following settings are available for programming only via compatible software: