User's Manual

Page 14 of 39 Rev: 3/6/2012 9:45 AM
Stop SwitchLinc from Responding
If you no longer want a controller button to control SwitchLinc follow these directions. Note: If you ever
wish to un-install SwitchLinc, it is important that you remove all SwitchLinc responder links. Otherwise,
controllers will retry commands repetitively, creating network delays.
1) Press & hold controller set button until beep
3
LED will start blinking
2) Press & hold controller set button until beep
LED will continue blinking
3) Press & hold SwitchLinc set button until double-beep
Controller LED will stop blinking
4) Test by tapping controller button on and off
SwitchLinc will no longer respond
Stop SwitchLinc from Controlling (Remove a Responder)
If you no longer want SwitchLinc to control another device (or are removing SwitchLinc) it is important that
you follow the instructions below for each responder.
1) Press & hold SwitchLinc set button until beep
LED will start blinking green
2) Press & hold SwitchLinc set button until beep
LED will start blinking red
3) Press & hold responder set button until double-beep (or LED blinks)
SwitchLinc will (Beep)-(Beep) and its LED will stop blinking
4) Test by tapping SwitchLinc on and off
Responder will not respond
Add Multiple Responders
1) Press & hold SwitchLincs set button until it beeps
SwitchLinc status LED will start blinking green
2) Tap SwitchLinc set button
SwitchLinc status LED will continue blinking green
3) For each responder you are adding
a. Tap on or off or press & hold to adjust to desired responder state
b. Press & hold responder set button until it beeps (or LED flashes)
SwitchLinc will (Beep)-(Beep)
4) After all responders have been added, tap SwitchLinc set button
SwitchLinc LED will stop blinking
5) Test by tapping SwitchLinc on and off a couple of times
All the responders added will
respond
Remove Multiple Responders
1) Press & hold SwitchLinc set button until it beeps
SwitchLinc status LED will start blinking green
2) Press & hold SwitchLinc set button again until it beeps again
SwitchLinc status LED will start blinking red
3) Tap SwitchLinc set button
SwitchLinc status LED will continue blinking red
4) For each responder you are removing
a. If multi-button device, tap the responding button
b. Press & hold responder set button until it beeps (or LED flashes)
3
For devices without beepers hold until its LED begins blinking (this may take 10+ seconds)