User's Manual

Page 16 of 39 Rev: 3/6/2012 9:45 AM
X10 Setup
SwitchLinc ships with no X10 address assigned.
Add X10 Address
1) Press & hold set button until beep
LED starts blinking green
2) Send the X10 address 3 times (with or without commands)
SwitchLinc will (beep)-(beep) and LED stops blinking
3) Test by sending X10 on and off commands
Light / load will turn on and off
Remove X10 Address
1) Press & hold set button until beep
LED starts blinking green
2) Press & hold set button until beep
LED starts blinking red
3) Send the X10 address 3 times (with or without commands)
SwitchLinc will (beep)-(beep) and LED stops blinking
4) Test by sending X10 on and off commands
SwitchLinc will not respond
Other X10 Setup
For other X10 setup instructions visit http://www.smarthome.com/insteon-x10-programming.html