User's Manual

Page 8 of 39 2477S - Rev: 3/6/2012 9:45 AM
Installation
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
This product is intended for installation in accordance with the National Electric Code and local regulations in the United States or
the Canadian Electrical Code and local regulations in Canada. Use indoors only. This product is not designed or approved for
use on power lines other than single-phase voltages between 100V and 277V, 50/60Hz. Attempting to use this product on non-
approved power lines may have hazardous consequences.
Recommended installation practices:
 Use only indoors or in an outdoor rated box
 Be sure that you have turned off the circuit breaker or removed the fuse for the circuit you are installing this product into.
Installing this product with the power on will expose you to dangerous voltages.
 The wires connecting SwitchLinc to the incoming power must be protected by a fuse or circuit breaker of 20-amps or less
 Connect using only copper or copper-clad wire
 This product may feel warm during operation. The amount of heat generated is within approved limits and poses no
hazards. To minimize heat buildup, ensure the area surrounding the rear of this product is as clear of clutter as possible.
 To reduce the risk of overheating and possible damage to other equipment, do not use this product to control Loads in
excess of the specified maximum(s) or, install in locations with electricity specifications which are outside of the product’s
specifications. If this device supports dimming, please note that dimming an inductive Load, such as a fan or transformer,
could cause damage to the dimmer, the load bearing device, or both. If the manufacturer of the load device does not
recommend dimming, use a non-dimming INSTEON on/off switch. USER ASSUMES ALL RISKS ASSOCIATED WITH
DIMMING AN INDUCTIVE LOAD.
Identifying the Electrical Wires in your Home
 Line - usually Black, may also be called HOT, LIVE or Power, carries 100 - 277VAC electricity into the wall box
 Neutral - usually White commonly daisy chained from box to box usually appearing as a White wire bundle
 Load – usually Black from a separate cable jacket
 Ground - Bare wire or metal fixture (if grounded)
IMPORTANT!
 Each INSTEON product is assigned a unique INSTEON ID, which is printed on the product’s label. Please take note for
future reference
 If you have any difficulties or questions, consult an electrician. If you are not knowledgeable about, and comfortable with
electrical circuitry, you should have a qualified electrician install the product for you.
Tools Needed
 Slotted screwdriver • Phillips screwdriver
 Wire cutter / stripper • Voltage Meter