User's Manual

Page 9 of 39 Rev: 3/6/2012 9:45 AM
Installing SwitchLinc (in circuits with 1 Switch)
1) Turn off breaker
1
supplying power to wall box
2) Remove wallplate and unscrew old switch
3) Gently pull out and disconnect wires from old switch
2
4) Turn breaker back on
5) Check old switch wires with a voltage meter to identify Line and Load
6) Turn breaker back off
7) Connect wires as follows
Sequence SwitchLinc Home Wire Commonly
1 Copper Ground Bare, green or green screw
2 White Neutral White bundle in back of box
3 Red Load
4 Black Line
8) Gently place SwitchLinc into wall box with LED bar on left and screw into place
9) Turn breaker back on
SwitchLinc LED bar and connected load will turn on
10) Test by tapping SwitchLinc on and off
11) Reinstall the wallplate
1
If multi-gang box, turn off all breakers (or fuses) that could possibly be supplying power to the box
2
If the wires cannot be detached, cut the wires where they enter switch and strip ½” of insulation off ends