User's Manual
Table Of Contents
- Getting Started
- INSTEON Links
- Understanding Linking
- Linking to the INSTEON Hub using the iOS or Android App
- Linking with a Single-Button Controller
- Linking with a Multi-Button Controller
- Multi-Linking or Making a Scene
- Unlinking from a Single-Button Controller
- Unlinking from a Multi-Button Controller
- Multi-Unlinking or Removing a Scene
- Software-Only Features
- Always-On Wiring
- Appendix
21
INSTEON Glossary
Controller The INSTEON transmitter
Responder The INSTEON receiver
Blinking
Dual-Band An INSTEON device that can send and receive both INSTEON powerline signals and
INSTEON radio frequency signals
Ramp Rate
On-Level The preset brightness level a device will return to when turned on
INSTEON A dual-band, mesh networking technology developed by INSTEON. The world’s most
Link A one way association between a controller and responder
Linking A method for associating INSTEON controller buttons with groups of INSTEON responders
such that the responders instantly return to a memorized state when the button is pushed.
Links can be made manually with the set button or using software.
Unlinking The process by which an INSTEON device can remove stored links. Just as with linking,
unlinking is a one-way process and should be performed in both directions for devices that
are both controllers and responders of each other, as in a 3-way switch scenario.
Multi-Linking
/ Unlinking
A special mode that allows more than one link to be either created or removed
simultaneously, without laborious set button presses. When in linking or unlinking mode, an
INSTEON device will continue to link to other devices until the set button is tapped or four
Factory Reset
Load The device that you are controlling (e.g. a light bulb, ceiling fan, etc.)
relay-based device.
Retry A 2nd (or subsequent) attempt by a controller to send an INSTEON signal, usually after an
Scene
thermostat adjusts to 72º.
Set Button A button on an INSTEON device that is used for setting or changing its properties
Simulcast A method for increasing the reliability of message delivery in a network. When a node in
a network sends a message, every other node that hears the message retransmits it at
precisely the same time based on a global clock, provided that the message has not already
because each node adds its energy to the signal, much like voices in a choir. Simulcasting
is much simpler than message routing because there are no routing tables to maintain and
nodes can join the network without any installation procedure.
X10 A legacy powerline networking technology. Many INSTEON devices are backwards
compatible with X10 devices by setting a house and unit code.