User's Manual
Table Of Contents
- About Micro On/Off
- Before Installation
- Identifying the Electrical Wires in Your Home (North America only)
- Identifying the Electrical Wires in Your Home (Europe/Australia/New Zealand)
- Installation
- Switch Operation Mode
- 3-Way Toggle Mode (Latching Switches Only, Default)
- Local Control Operation
- Adjust Local Settings
- INSTEON Setup
- INSTEON Controllers, Responders and Links
- Configure INSTEON Settings
- Make Micro Module a Responder (Set button)
- Make Micro Module a Responder (Switch)
- Make Micro Module a Controller (Set button)
- Make Micro Module a Controller (Switch)
- Groups
- Scenes
- Make Micro Module a Controller of Multiple Responders
- Remove Micro Module as a Controller
- Remove Micro Module as a Responder
- Remove Micro Module as a Controller of Multiple Responders
- Factory Reset
- X10 Setup
- Specifications
- Troubleshooting
- Certification and Warranty
- Certification
- FCC and Industry Canada Compliance Statement
- The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in re...
- WARNING: Changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- Cet appareil a été testé et s’avère conforme aux restrictions relatives aux équipements numériques de classe B, d’après l’article 15 des règlements du Conseil supérieur de l’audiovisuel américain (FCC). Ces restrictions ont été instaurées pour offrir ...
- • Éloignez l’appareil du composant qui reçoit les ondes. • Branchez l’appareil dans une prise de courant CA différente de celle du composant qui reçoit les ondes. • Au besoin, consultez votre marchand électronique ou un technicien spécialisé dans le s...
- Declaration of Conformity
- ETL/UL Warning (Safety Warning)
- Limited Warranty
- Limitations
Page 2 of 21 2443-222/2443-422/2443-522 - Rev: 9/24/2014 12:46 PM
About Micro On/Off ................................................................................................................................... 3
Features and Benefits ............................................................................................................................. 3
Before Installation ..................................................................................................................................... 3
Identifying the Electrical Wires in Your Home (North America only) ........................................................ 4
Identifying the Electrical Wires in Your Home (Europe/Australia/New Zealand) ...................................... 4
Identify Switch Type ................................................................................................................................ 4
Installation ................................................................................................................................................. 5
Switch Operation Mode ............................................................................................................................ 6
Change to Single Momentary Mode ........................................................................................................ 6
Change to Dual Momentary Mode ........................................................................................................... 6
Change to Latching Mode (default) ......................................................................................................... 6
3-Way Toggle Mode (Latching Switches Only, Default)......................................................................... 7
Local Control Operation ........................................................................................................................... 7
Latching Wall Switch (Default) ................................................................................................................. 7
Single Momentary Switch ........................................................................................................................ 8
Dual Momentary Switch........................................................................................................................... 8
Adjust Local Settings ............................................................................................................................... 8
Change LED Brightness (or turn it off)..................................................................................................... 8
Error Blink ................................................................................................................................................ 8
Blink on Traffic ......................................................................................................................................... 9
Beep on Button Press.............................................................................................................................. 9
Programming Lock .................................................................................................................................. 9
INSTEON Setup ......................................................................................................................................... 9
INSTEON Controllers, Responders and Links ......................................................................................... 9
Configure INSTEON Settings .................................................................................................................. 9
Make Micro Module a Responder (Set button) ........................................................................................ 9
Make Micro Module a Responder (Switch) ............................................................................................ 10
Make Micro Module a Controller (Set button) ........................................................................................ 10
Make Micro Module a Controller (Switch) .............................................................................................. 10
Groups................................................................................................................................................... 11
Scenes .................................................................................................................................................. 11
Make Micro Module a Controller of Multiple Responders ...................................................................... 11
Remove Micro Module as a Controller .................................................................................................. 12
Remove Micro Module as a Responder ................................................................................................ 12
Remove Micro Module as a Controller of Multiple Responders ............................................................. 12
Factory Reset ........................................................................................................................................ 12
X10 Setup................................................................................................................................................. 13
Add X10 Address .................................................................................................................................. 13
Remove X10 Address............................................................................................................................ 13
Specifications .......................................................................................................................................... 14
Troubleshooting ...................................................................................................................................... 17
Stuck/Disabled Button ........................................................................................................................... 18
Phase Bridge Detect Beacon/RF Range Test ....................................................................................... 19
Certification and Warranty ..................................................................................................................... 20
Certification ........................................................................................................................................... 20
FCC and Industry Canada Compliance Statement ................................................................................ 20
Declaration of Conformity ...................................................................................................................... 20
ETL/UL Warning (Safety Warning) ........................................................................................................ 20
Limited Warranty ................................................................................................................................... 21
Limitations ............................................................................................................................................. 21