User's Manual

ManualsBrandsSmartLabs ManualsElectronicsMicro Module

Table Of Contents

2444-222, 2444-422, 2444-522 Rev. 9/24/2014 12:42 PM / See Owner’s Manual for Warranty Information.

Protected under U.S. and foreign patents (see www.insteon.com/patents)

Make Micro Module a Controller

These settings can be configured remotely via software (sold separately). You can also add Micro module to your network

manually by following the instructions below. Note: you must perform these steps before reinstalling the wall switch.

1) Press and hold Micro module set button until it beeps

Micro module LED will start blinking green

2) You will have four minutes to complete the next steps before linking mode times out

Adjust responder to desired state

3) Press and hold responder set button until it double-beeps

Micro module will double-beep and its LED will stop blinking

4) Test link by tapping switch connected to Micro module to turn up/down

Responder will respond appropriately

Assign an X10 Address

1) Press and hold Micro module set button until it beeps

Micro module LED will start blinking green

2) Send the X10 address 3 times (with or without commands)

Example: A1-A1-A1-AON or A1-AON-A1-AON-A1-AON

Micro module will double-beep and its LED will stop blinking

3) Test by sending X10 on and off commands

The motor connected to Micro module will respond appropriately

Owner’s Manual and Tech Support

Visit: http://www.insteon.com/support for complete manual, online tech support and latest product documents.

Call: INSTEON Support Line at 866-243-8022

FCC Compliance

This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept

any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme à l’article 15C des règlements de la FCC et CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit

pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Micro module

(Controller)

Responder