Use and Care Guide

2
INSTALLATION INSTRUCTIONS
1. Use sand to mark the outline of your pond. Fig. 1
Fig. 1
2. Dig out your pond and remove and debris or rocks that might
damage your liner. Add approximately 2 in. of sand to the pond
area. The sand functions as a cushion beneath your pond liner.
Spread the sand over the entire area and compact it. Fig. 2
Fig. 2
3. Open the liner and drape it across the pond area, making sure to
leave at least 10in. of overlap around the perimeter of the hole.
Begin to fill the pond with water, smoothing out any wrinkles as
you do this. Fig. 3
Fig. 3
4. When the pond is full, bury the excess liner in a small trench
around your pond with stones and rocks, according to your
landscape design. Fig. 4
Fig. 4
Printed in USA